Turning Eccentrics in Three-Jaw Chuck: Difference between revisions
Jump to navigation
Jump to search
(Created page with "Category:Construction The Model Craftsman, February 1938 When you want to produce off-center work in your lathe, an independent, four-jaw chuck isn't altogether neces...") |
No edit summary |
||
| Line 3: | Line 3: | ||
When you want to produce off-center work in your lathe, an independent, four-jaw chuck isn't altogether necessary. A three-jaw chuck will do the job just as well, as the darwing illustrates. Suppose you wish to make an eccentric, and have to drill or bore the hole in the center accurately. Measure the distance that the eccentric is to be off-center, then take a small block of brass and file it to this width. Select a piece of round stock of the correct outside diameter for the eccentric, and insert it in the chuck, using the brass block for a spacer. | When you want to produce off-center work in your lathe, an independent, four-jaw chuck isn't altogether necessary. A three-jaw chuck will do the job just as well, as the darwing illustrates. Suppose you wish to make an eccentric, and have to drill or bore the hole in the center accurately. Measure the distance that the eccentric is to be off-center, then take a small block of brass and file it to this width. Select a piece of round stock of the correct outside diameter for the eccentric, and insert it in the chuck, using the brass block for a spacer. | ||
[[File:TurningEccentricInThreeJawChuck TheModelCraftsmanFeb1938.jpg|thumb|center|400px]] | |||
Revision as of 09:38, 28 January 2022
The Model Craftsman, February 1938
When you want to produce off-center work in your lathe, an independent, four-jaw chuck isn't altogether necessary. A three-jaw chuck will do the job just as well, as the darwing illustrates. Suppose you wish to make an eccentric, and have to drill or bore the hole in the center accurately. Measure the distance that the eccentric is to be off-center, then take a small block of brass and file it to this width. Select a piece of round stock of the correct outside diameter for the eccentric, and insert it in the chuck, using the brass block for a spacer.
