Interference fit: Difference between revisions
Jump to navigation
Jump to search
(Created page with "Category:Definitions An interference fit, also known as a press fit or friction fit, is a fastening between two parts which is achieved by friction a...") |
|||
| Line 8: | Line 8: | ||
* [https://en.wikipedia.org/wiki/Interference_fit "Interference fit", <i>Wikipedia</i>] | * [https://en.wikipedia.org/wiki/Interference_fit "Interference fit", <i>Wikipedia</i>] | ||
* [http://www.rypn.org/forums/viewtopic.php?f=1&t=2138 "Wheel to axle fits"] | |||
* [http://www.engineersedge.com/general_tolerances.htm Tolerance Class Chart] | |||
* [http://www.practicalmachinist.com/vb/general-archive/press-fits-82434/ "Press fit"] | |||
* [https://www.youtube.com/watch?v=-OZEFQIA8CU "Interference fit", <i>YouTube.com</i>] | |||
Revision as of 10:00, 29 December 2016
An interference fit, also known as a press fit or friction fit, is a fastening between two parts which is achieved by friction after the parts are pushed together, rather than by any other means of fastening.
A press fit is also required to mount wheels on an axle to make a wheel set.