Lathe Tool Setup: Difference between revisions
Jump to navigation
Jump to search
(Created page with "Category:Construction [[File:Lathe Tool Setup World Of Model Engineering No3.jpg|thumb|center|300px|From "The Lathe" by Stan Bray, "World of Model Engineering" No 3, 1989...") |
No edit summary |
||
Line 2: | Line 2: | ||
[[File:Lathe Tool Setup World Of Model Engineering No3.jpg|thumb|center|300px|From "The Lathe" by Stan Bray, "World of Model Engineering" No 3, 1989, http://www.model-engineer.co.uk/sites/7/documents/wome-3-pt1.pdf]] | [[File:Lathe Tool Setup World Of Model Engineering No3.jpg|thumb|center|300px|From "The Lathe" by Stan Bray, "World of Model Engineering" No 3, 1989, http://www.model-engineer.co.uk/sites/7/documents/wome-3-pt1.pdf]] | ||
[[File:Drilling starts with center drill.jpg|thumb|center|300px|All drilling operations should start with a center drill; this gives an accurate and clean starting point, and reduces the chance of the drill bit "walking" off center.]] |