Dnevil: I used a low-cost sheet metal brake from Harbor Freight to bend all the roof sections. Here is the long roof section after begin cut in two parts. This is the longest section and the hardest to bend in this jig. I used all the C-clamps I could round...

2015-09-14T03:41:11Z

New page

I used a low-cost sheet metal brake from Harbor Freight to bend all the roof sections. Here is the long roof section after begin cut in two parts. This is the longest section and the hardest to bend in this jig. I used all the C-clamps I could round up. The bending operation worked smother and easier by spraying lubricant (WD-40) on the sheet metal where it was begin bent. Photo by [[Daris A Nevil]], June 2015.

File:KitsapCabooseBatteryBox9.jpg - Revision history

Dnevil: I used a low-cost sheet metal brake from Harbor Freight to bend all the roof sections. Here is the long roof section after begin cut in two parts. This is the longest section and the hardest to bend in this jig. I used all the C-clamps I could round...